Operation Manual
ENGLISH
CHRONO
The chrono allows to program 4 time spans within a day to use every day of the week.
The switch-on and switch-o time can be set in every time slot, along with the days of use of the programmed time slot and the
desired room temperature (07 - 40°C).
RECOMMENDATIONS
The ignition and switch-o times must be within the arc of one day,
from 0 to 24 and not over several days:
Before using the chrono function, set the current day and time.
Therefore check that the points listed in the “Set clock” sub-chapter
have been followed, so that the chrono function works. Aside from
programming it, activate it as well.
EXAMPLE:
SWITCHON TIME 07:00
SWITCHOFF TIME 18:00
CORRECT
IGNITION 22:00 SWITCH
OFF 05:00
INCORRECT
V2 AIR
The menu allows to adjust the speed of the ducted fan in percentage.
CONTROLS PROCEDURE
Press key 6 and SET CLOCK will appear.
Press key 2 several times until USER is displayed.
Press key 6.
Press key 2 until "V2 AIR" appears.
Use keys 4 -5 to increase (4) or decrease (5)
Press key 6 to conrm and key 1 to return to the previous menus
up to the initial status.
2
ENABLE CHRONO
It allows to enable/disable the chrono and the various time slots.
CONTROLS PROCEDURE
Press key 6 and SET CLOCK will appear.
Press key 2 several times until ENABLE CHRONO is displayed.
Press key 6, to conrm and use keys 4-5 to enable "ON" or disable "OFF" the chrono.
Use keys 2 -3 to select the desired time slot
Use keys 4-5 to enable "ON" or disable "OFF" the selected time slot.
Press key 1 several times to conrm and exit the menu.
RESET
Allows to reset all values modiable by the user to the default values. The modied data is the following:
CONTROLS PROCEDURE
Press key 6 and SET CLOCK will appear.
Press key 2 several times until USER is displayed.
Press key 6.
Press key 2 until "RESET" appears.
Press keys 4-5 to select ON and press key 6.
"DONE" will appear on the display to conrm
20