User manual

30
Displays
Display Reason
off
Stove o
sTaRT
The start phase is in progress
pelleT feeDinG
The continuous feeding of the pellets during the ignition phase is in progress
iGniTion
The ignition phase is in progress
sTaRT-up
The start-up phase is in progress
BuRn poT
cleaninG
The automatic burn pot cleaning is in progress
final cleaninG
The nal cleaning is in progress
sTanD-By
coolinG
Start-up attempt while the stove is still in cooling mode
Every time the stove displays one of the alarms listed above it will switch-o automatically.
The alarm can only be released using button 1 when it switch-o has been completed. The stove can only be
switched back on when it completely cold
WoRk
The normal operating phase is in progress, the stove is operating at the set power
MoDulaTion
The stove is operating at minimum
sTanD - By
Stove o waiting for re-ignition due to an external thermostat
The stove will only re-start when the external thermostat will request it
sTDBy
Black ouT
The stove is cooling after a power cut.
Once cooling is complete, it will automatically ignite
RooM T
Displays room temperature (in the models where provided)
Hoff
Stove o due to water temperature over set
As soon as the water temperature drops below the set parameters, the stove will switch back on
anTi-fReeze
The anti-freeze function is in progress as the H2O t° is below the factory set threshold
the pump is active until the water reaches the pre-set factory parameter +2°C
anTilock
The pump anti-locking function is in progress (only if the stove has been in O status for at least 96 hours)
the circulator is activated for the amount of time set by the manufacturer to prevent it from locking
| enGlisH