User manual
24
| ENGLISH
USER MENU
SET CLOCK
see chapter: rst ignition settings
CONTROLS PROCEDURE
Press key 6 and SET POWER will appear
Press key 2 several times until SET ADJUSTMENTS is displayed
Conrm using key 6
Press key 2 until pellet IS DISPLAYED
Press 4 to increase the load and 5 to decrease it
Press key 6 to conrm and key 1 to return to the previous menus
up to the initial status
NO FUEL:
the stove can never develop a suitable ame, tending to remain very low even at high powers.
at minimum power the stove tends to almost switch-o taking the stove into “NO PELLETS” alarm condition.
when the stove displays the “NO PELLETS” alarm, there may be non-burned pellets inside the burn pot.
EXCESS FUEL:
the stove develops a very high ame even at low power.
the panoramic glass is very dirty, obscuring it almost totally.
the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only
burned partially.
The regulation to be performed is a percentage. Therefore a modication of this parameter will lead to a proportional
variation of all stove feeding speeds.
Feeding is from -30% to +20%.
Follow the procedure on the display to perform this adjustment:
CHRONO
The chrono allows to program 4 time spans within a day to use every day of the week.
The switch-on and switch-o time can be set in every time span, along with the
days of use of the programmed time span and the desired water temperature (65
- 80°C).
RECOMMENDATIONS EXAMPLE
The ignition and switch-o times must be within the arc of
one day, from 0 to 24 and not over several days.
Before using the chrono function, set the current day and
time. Therefore check that the points listed in the “Set clock”
sub-chapter have been followed, so that the chrono function
works. Aside from programming it, activate it as well.
Switch-on time 07:00
CORRECT
Switch-o time 18:00
Switch-on time 22:00
INCORRECT
Switch-o time 05:00