Specifications

24
24
9 USE
The stove you have purchased uses pellets as fuel. This type of material is produced from natural waste
from woodworking. Using a special process, which does not require the use of any binder or additive, the
shavings are compressed in industrial machines under high pressure and become solid wooden pellets. The
combustion of raw material which is not pellet, in our stove
IS FORBIDDEN.
Failure to respect these instructions annuls all the warranties and could affect the safety of the appliance.
The first two or three times the stove is lit, following recommendations should be observed:
• No children should be present, as the vapours emitted can be harmful for health.
Adults should not stay for very long either.
• Do not touch the surfaces, as they could still be unstable.
• Air the room well several times.
• The hardening of the surfaces is completed after several heating processes.
• This stove
must not be used as waste incinerator
• Let the stove functioning for 2-3 days at the med. Power (on the display you read 3) for a good
settlement of the components.
ONLY FOR ECOLOGICA IDRO: We suggest to set the stove on power 5, the stove will drop down
automatically to the lowest level, according to the water temperature.
BASIC INSTRUCTIONS
8.1 DESCRIPTION OF CONTROL PANEL ALARMS
It is ON when the chronothermostat is activated.
It is ON when the room temperature is lower than the set of the temperature which has been set.
It is OFF when the room temperature is greater than the set of the temperature which has been set.
It is ON when the function day/night temperature is activated.
It is ON when the ignition sparking plug is not connected.
It is ON when an alarm occurs.
It is ON when the smoke exhaust motor is ON.
It is ON when the feeding gearmotor is running.
It is ON when the tangential fan is ON.
Only version Divina Plus. It is ON when the fan for the canalization is ON
It is ON when an additional thermostat is connected
Only Ecologica Idro version. It is ON when the circulator (pump) is ON
It is ON when the display receives the signal from the remote control