Technical data

4 - 8 Page Date: 6. April 2010
Section 4
Normal Procedures
Pilot´s Operating Handbook
EXTRA 300LT
4.6 CLIMB
Climbs may be performed up to 2700 RPM. RPM above 2400 should, however, be used only
when necessary for maximum performance in order to avoid unnecessary noise.
Turn boost pump "OFF".
4.7 CRUISE
1. Altitude As selected
2. Throttle/RPM ADJUST for cruising speed
3. Mixture ADJUST for minimum fuel consumption
4. Trim As required
5. Fuel CHECK periodically
4.8 LANDING PROCEDURES
4.8.1 DESCENT
1. Throttle REDUCE
2. Mixture "FULL RICH"
3. RPM Control SET to 2400 RPM
4. Trim ADJUST
5. Fuel selector* "ACRO & CENTER TANK"
N O T E*
Although safe operation does not require the use of the tanks in a specific sequence,
it is recommended to set fuel selector to "ACRO & CENTER TANK" position!
4.8.2 APPROACH
1. Boost pump ON
2. Mixture SET to "RICH"
3. Airspeed REDUCE to approach speed
4. Propeller SET to low pitch ("HIGH RPM")
N O T E
It is recommended to set the RPM to 2400 during approach and landing in order to
avoid unnecessary noise. In case of "Go Around", RPM control must be set to max.
RPM before applying power.
4.8.3 BEFORE LANDING
1. Landing approach PROCEED
2. Airspeed on final maintain 85 KIAS (157 km/h)
3. Elevator trim ADJUST