Warranty

In certain geographic areas where mildew may be a problem, substitute one quart of 5% sodium
hydrochloride (e.g. Clorox), for one quart of water in the above solution. If the structure is
extremely dirty, it is recommended that you start washing from the top and work down to the
bottom. Apply cleaning solution and let it stand several minutes so the dirt will loosen. The siding
must be rinsed thoroughly with clear water to avoid staining and/or streaking.
CAUTION: Be sure to follow all precautions and warnings on the product label of the above
referenced chemicals to prevent personal injury. Do not exceed the recommended
concentrations of cleaners. Doing so can cause damage to the product’s surface. Avoid skin and
eye contact with the solution, and in all cases follow manufacturer’s instructions for the use of
cleaning compounds and solutions. Avoid use of abrasive-type cleaners and strong solvents.
Test any cleaner on an inconspicuous area before applying to major areas. To minimize
streaking, always clean from the bottom to the top and follow with a rinsing of clear water.
Excessive scrubbing is unnecessary, can be harmful to the products, and may cause undesirable
glossy areas over the finish.
Fire Safety
The use of mineral filled polypropylene composites allows Exteria siding to withstand a wide
performance temperature range from -40°F to 190°F when the material has been properly
installed and mounted.
Due to the nature of polypropylene’s organic content, Exteria products are not designed to
withstand extremely high application temperatures. Like wood, these organic products are
combustible and caution must be applied when using outdoor grills, heating guns, blow torches,
electrical equipment and other heat sources in close proximity to your siding. Building owners,
occupants and outside maintenance personnel should always take precautions to keep sources of
fire and combustible materials, such as dry leaves, dry mulch and trash away from siding. Exteria
is not responsible for damage to panels caused by high application or installation temperatures, or
accidents caused by third parties which damage the panels, siding or its integrity once the panels
have been installed.
Exteria products fall into Class C flame spread category of ASTM E84. Exteria does not install
siding. It is the responsibility of the contractor or installer that building codes are met and Exteria
is not responsible if the product is improperly used on buildings that require Class A or Class B
rated products.
Miscellaneous:
• Exteria reserves the right to discontinue or change any product design, color or accessory
without notice to the original purchaser or transferee.
• EXTERIA SHALL NOT BE LIABLE FOR ANY INCIDENTAL, INDIRECT OR
CONSEQUENTIAL LOSS OR DAMAGE RESULTING FROM ANY BREACH OF ANY
WARRANTY OR OTHERWISE RELATING TO ITS PRODUCTS. SOME STATES DO
NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.
• IN NO EVENT WILL EXTERIA'S LIABILITY OR OBLIGATION WITH RESPECT TO ANY
PRODUCT EXCEED THE PURCHASE PRICE THEREOF RECEIVED BY EXTERIA.
• This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state.
• This warranty is effective only for Exteria siding purchased after April 20, 2011.
POLICY-EXEC-002Rev 2013- Exteria Building Products Warranty.docx