User`s guide

27
14. Configure OneBridge Service. See Configuring the OneBridge Service.
15. Click Yes to start the OneBridge Service.
Configuring the Exchange Adapter
The Exchange Settings wizard configures the Exchange Adapter. The Exchange Adapter can also be remotely configured using
the Admin program.
1. On the Access Mode screen, enter the Name of the Exchange server.
2. Select the access mode from the options listed, and then click Next. The remainder of the installation procedure is
dependent upon this selection:
• Exchange User Mode
• Exchange Administrator Mode
3. If Exchange User Mode was selected as the access mode, the Resolver Account screen will appear. Select the resolver
account type:
• Windows NT account
• Exchange Guest account
The options available on the Resolver Account screen depend on the account type that was selected. Enter the required
information for the account type.
4. If an Exchange Listener is to be setup to detect user changes, enter the server information on the Exchange Listener
Configuration screen.
5. Click Finish.