User`s guide

26
Exchange Administrator Mode
Benefits
• The Exchange Adapter has higher performance.
Requirements
• The complete Outlook 2000/2003 Client (including CDO) must be installed on the computer that is running the Exchange
Adapter.
• The Exchange Adapter and Exchange Server must be located in the same domain.
• The account running the Adapter service needs to have the Exchange service account Admin role that is assigned through
the Exchange Administration program.
• If Exchange Adapter is installed on Windows 2000, the Adapter service cannot be run as the local system account. It is
necessary to select an account that has administrator privileges for the Adapter service.
Important Due to issues with Outlook 2000, it is not recommended that the Exchange Adapter be installed on the same
computer as the Exchange Server.
Installation Procedure
1. Install complete Outlook 2000/2003 Client on the target computer. You may use your Microsoft Outlook CD to install CDO.
During installation, select Custom Install, and then select the CDO component.
2. Using the Outlook 2000 Client, connect to the Exchange server to verify the installation. If you are prompted to set Outlook
at the default mail client, select Yes.
3. From the OneBridge Installer screen, select Sync Server and click install now.
4. Click Yes to accept the License Agreement.
5. Choose the type of installation:
• Single Node Configuration – Select this option to install the server and adapter software on a single computer.
• Multiple Node Configuration – Select this option to install the server and adapter software on separate computers,
and then click Adapter Software.
6. Select the Exchange Adapter from the list. Clear any other adapters that are not required.
7. Choose the install directory for the program and click Next.
8. Choose the data directory for the program and click Next. The data directory stores configuration and user backup
information. You may want to select a location that is available for backups, such as a network drive.
Note If the Notes adapter was also selected, the Notes Adapter Configuration is displayed.
9. On the Access Mode screen, enter the Name of the Exchange server.
10. Select the access mode from the options listed, and then click Next. The remainder of the installation procedure is
dependent upon this selection:
• Exchange User Mode
• Exchange Administrator Mode
11. If Exchange User Mode was selected as the access mode, the Resolver Account screen will appear. Select the resolver
account type:
• Windows NT account
• Exchange Guest account
The options available on the Resolver Account screen depend on the account type that was selected. Enter the required
information for the account type.
12. If an Exchange Listener is to be setup to detect user changes, enter the server information on the Exchange Listener
Configuration screen.
13. Click Finish.