User manual

 Manual or Automatic Start: Select Automatic to start datalogging
immediately when the Setup window is exited or Manual by using the
datalogger button at a later time.
 Click the SETUP button to save changes. Click the DEFAULT button to
set the Datalogger to its factory default condition. Click the CANCEL
button to abort the setup.
Notes: All stored data will be permanently erased when Setup is clicked. To save data,
click Cancel and download the data first and then re-enter the Setup mode.
The battery could expire before a logging session is finished recording a specified
number or sample points. Ensure that the available battery power is sufficient for
completing a given logging task. If in doubt, install a fresh battery before logging critical
data.
Download Data
To transfer the readings stored in the Logger to the PC:
A. Connect the Datalogger to the USB port.
B. Open the Datalogger software program if it is not still running
C. Click the Download icon .
D. The window shown below will appear. Click DOWNLOAD to begin
transferring data.