User manual

Operation
Datalogger Setup
Click the setup icon on the menu bar. The Setup window will appear
as shown below; descriptions for each field in the Setup window are
listed directly below:
 Sampling Setup: Set the Datalogger to record readings at a specific
rate. Rate and units are selectable.
 LED Flash Cycle Setup: Set to No Light, 10, 20, or 30 seconds. By
selecting the “No Light” option, the LEDs will not flash, thereby
conserving the battery life.
 Record Mode Setup: can be set to Normal or Motion Detection.
 Motion Detection Threshold Setup: Sets the acceleration detection
threshold when Motion Detection is enabled. If the acceleration value
exceeds the threshold, the Datalogger will record the event.