Owners Manual

9 MS6000-en-GB_V1.5 5/16
3.5 Observing a waveform
Press the AUTO button and a 1 KHz square wave of approx. 5V peak-to-peak will appear in the
display. Press the CH1 button and remove Channel 1. Move the Probe to the CH2 BNC, push the
CH2 button and repeat these steps to observe the test signal on Channel 2.
3.6 Probe Examination
3.7 Safety
When using the probe, keep fingers behind the guard on the probe body to avoid electric shock. Do
not touch metallic portions of the probe head while it is connected to a voltage source. Connect the
probe to the oscilloscope and connect the ground terminal to ground before starting any
measurements.