Owners Manual

26 MS6000-en-GB_V1.5 5/16
Probe Attenuation (F4)
(menu page 1)
1X
10X
100X
1000X
Select a value to match the probe attenuation factor so as
to ensure correct vertical readouts. Reduce bandwidth to
6MHz when using a 1X probe.
Invert (F2)
(menu page 2)
Off
On
Inverts the waveform relative to the reference level.
Reset (F3)
(menu page 2)
Resets Vertical settings to default
Ground Coupling
Ground Coupling is used to display a zero-volt waveform. Internally, the channel input is connected
with a zero-volt reference level.
Remove Waveform Display
To remove a waveform from the screen, first push the menu button to display the vertical menu, and
then push the appropriate Channel button to remove the waveform. A channel waveform which is
unnecessary to display can be used as a trigger source or for math operations.
3. VOLTS
Control the oscilloscope to magnify or attenuate the source signal of the channel waveform. The
vertical size of the display on the screen will change (increase or decrease). The key F3 may be used
to switch between Coarse and Fine. In the Fine resolution setting, the vertical scale readout displays
the actual VOLTS setting. The vertical scale changes only when the control is set to Course and the
VOLTS control is adjusted.