User Manual

RPM33-en-EU_V1.3 4/13
5
PreparingforMeasurements
Non‐Contact(Photo)TachometerPreparation
1. Applyasquarepieceofreflectivetapetothesurfaceoftheobjectundertest(nominaltape
size:0.5”/12mm).Besuretoaffixthetapeasclosetotheouteredgeoftheobjectundertest
aspossible.Seediagrambelow.


2. Ifnotalreadydone,unscrewandremovethemetercollar(itemnumber3intheDescription
sectiondiagram)
3. Proceedtothe“TakingMeasurements”sectionbelow.


ContactTachometerPreparation
1. Ifnotalreadydone,attachthecollar(itemnumber3intheDescriptionsectiondiagram)to
themeter.
2. Slidethecontactadaptorontothetachometer’sshaft.Besuretoaligntheadaptorwiththe
alignmentpinontheshaftofthecontactadaptor.
3. Attachacontactmeasurementaccessory(cone,wheel,orconcaveaccessory)ontothe
contactadaptor.
4. ForContactoperationthemetercanmeasureSurfaceSpeedorLength.Readthesection
titled“SurfaceSpeedandLengthMeasurementModes”laterinthisguidefordetails.
5. Followthestepsinthe“TakingMeasurements”sectionbelow.
