User Manual

3 MC108 V1.1 2/09

Operation

Power Supply

• The unit includes three Ni-MH rechargeable batteries.

• The unit can run from the batteries or from USB power when

the USB cable is connected to a PC or to the power adaptor.

• The Ni-MH batteries will recharge automatically when the

microscope is connected, with the USB cable, to a PC or to the

USB power adapter.

• When the recharger is in the power-off mode, the white LEDs will

flash twice every three seconds. If the recharger is in power-on

mode, the

icon will be shown on screen.

• After completely charging in the power-off mode, the white LEDs will

flash once every three seconds. After completely charging in the

power-on mode, the

icon will be shown on screen.

• Recharge Ni-MH batteries every few months, even if the system is

not used to maintain battery strength, this is suggested to extend battery longevity.

• For lengthy storage periods, remove batteries to prevent damage due to battery

leakage/ discharge.

• The unit may also use alkaline batteries. Do not mix battery types in use and do not

recharge alkaline batteries.

Powering the Unit

• Press the power button for 2 seconds and then enter the normal observation Mode.

The magnified images should now be shown on the screen.

• By placing the observed object below the aiming mark located on the back of the case,

the screen will display the observed image desired.

• You may adjust the transparent protector in front of the lens protector in order to

provide focus.

• Press the save button, or zoom wheel, to capture images for purposes of recording.

Controls

1. Optical zoom/focus

2. Aiming mark

3. Display

4. Zoom/ Snapshot

5. Return/Preview

6. Special effects/Up

7. Power

8. Tools

9. Brightness

10. Set/Save/Compare

11. Indicator

Optical Zoom/Focus dial

891011

