Product Manual

HDV600-EN-V2.0 5/11

Wireless transmitter

The wireless transmitter is intended for use in areas that are difficult to access or in situations

when is hard to maneuver the probe with the display attached. The probe can also be connected

directly to the monitor using the patch cord.

Note: The battery must be fully charged for wireless operation. A weak battery may result in

meter shut down.

Wireless Mode

1. Connect the AC adaptor to the transmitter and charge the

battery.

2. Attach the probe to the transmitter.

3. Press and hold the Power button for 4 seconds to turn the

monitor on, then select “WIRELESS” under the INPUT

SOURCE selection in the MENU screen.

4. Press and hold the Power button for 4 seconds to turn the

transmitter on. The camera video will be transmitter to the

monitor display.

Direct Mode

1. Connect the AC adaptor to the transmitter and charge the

battery.

2. Attach the probe to the transmitter.

3. Connect the patch cord between the transmitter and the monitor probe input connector

4. Press and hold the Power button for 4 seconds to turn the

transmitter on.

5. Press and hold the Power button for 4 seconds to turn the

monitor on, then select “DIRECT” under the INPUT

SOURCE selection in the MENU screen.

6. In the direct mode, light intensity is controled by the

buttons on the monitor, not by the buttons on the

transmitter.

Viewing a Stored Photo or Video in the Display

1. Press the ▲ button to access the pictures or videos in memory. Each button press will

step through the files with the file number appearing on the screen (i.e. IMG00005)

2. Pictures will appear with the photo icon on the display.

3. Videos will appear with the film icon on the display.

4. To play a video, select a video file and press the button. The play icon will appear

during playback. Press the button again to pause playback. The pause icon will

appear.