User Manual

Introduction
Congratulations on your purchase of the ExStik
®
EC400 Conductivity/Total Dissolved
Solids (TDS) / Salinity / Temperature meter. With the EC400’s dynamic cell-constant
technology it is possible to measure a wide range of Conductivity, TDS, and Salinity with
the same electrode. Careful use and maintenance will provide years of reliable service.
Powering the ExStik™
The ExStik
®
uses four (4) CR2032 Lithium Ion Batteries (included). If the batteries are
weak, the ‘BAT’ indicator appears on the LCD. Press the ON/OFF key to turn the ExStik
®
on or off. The auto power off feature shuts the ExStik
®
off automatically after 10 minutes of
inactivity to preserve battery life.
Getting Started
• Remove the cap from the bottom of the ExStik to expose the conductivity electrode.
• Before the first use or after storage, rinse the electrode in deionized water and dry.
• For best results, calibrate for conductivity with a standard in the expected range of
the sample. For maximum accuracy calibrate from low conductivity value standards
to high value standards.
• Store dry.
99 Washington Street
Melrose, MA 02176
Phone [phone]
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Back to the Extech EC400 Product Info Page
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX [phone] - TestEquipmentDepot.com