User Manual

DL160 V1.0 03/10

Introduction

Congratulations on your purchase of this Dual Input Voltage / Current

datalogger. With this meter, you can monitor and log data (Voltage/Voltage,

Current/Current or Voltage/Current) over long periods of time and then easily

transfer the data to a pc for viewing and evaluation. The LCD display

provides real time data, Max/Min data and time information. This meter is

shipped fully tested and calibrated and, with proper use, will provide years of

reliable service.

Safety

Warning!

• Do not attempt to make measurement in flammable gaseous areas!

• When testing a non-insulated cable, pay attention to avoid short circuits.

• Do not attempt to use the instrument when your hand is wet!

• Do not input over range during measurements.

• Never open the battery cover during measurements.

• Stop using the instrument when there is any structural defect or exposed

metal parts.

• Do not install substitute parts or make modifications on the meter.

• Never replace the battery in moist areas.

• Ensure the meter is disconnected and switch off before opening the

battery cover to replace the battery.

• Do not attempt to place the instrument in high vibration areas.

• Do not expose the meter to direct sunlight, high temperature and high

moisture environment.

• Switch off the meter after use. Remove the AAA batteries when the meter

will be stored for a period of time..

• When cleaning, do not use abrasives or solvents on the meter, use a

damp cloth and mild detergent only.