User Guide

Specifications subject to change without notice.
Copyright © 2007-2008 Extech Instruments Corporation. All rights reserved including the right of reproduction in whole or in part in any form.
www.extech.com
6/16/08 - R2
Features:
Local continuity checking - is accomplished by a bright
flashing LED and loud pulsating beeper
Remote continuity with the use of the remote probe,
it does not tie-up two people when identifying and labeling
long distance wire/cable runs
Flashing remote probe - Two lead, bi-color (red/green) LED
probe allows a single user to identify up to three wires or
cables at a time for correct labeling with only one trip to
the other end location - cuts down on multiple trips back
and forth
Polarity verification - Drives a 20mA DC current pulse
through the wires or cables under test to the bi-color
remote probe; This enables the technician to identify each
of the wires under test at the other end of the cable run and
eliminates the possibility of false high impedance readings
Lightweight/Pocketsize - clips on and hangs from the
cable(s) under test without falling off
Dims: 3.6x2.2x1.14" (90x57x29mm); Wt: 9.2oz (260g)
Complete with remote probe, test leads with alligator clips,
9V battery and pouch
One person operation
For wire and cable testing; both local and remote
Continuity Tester Pro
Use for local continuity or for remote
wiring identification.
RED LED means wiring is reversed.
GREEN LED means wiring is
properly identified.
Continuity Tester includes Remote probe with bi-color LED for wire identification highlight
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Back to the Extech CT20 Product Info Page
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com

Summary of content (1 pages)