Product Manual

BR200-BR250-EN-V6.2 -7/10

Troubleshooting:

Power Reset for the LCD Unit

In the event of a power failure in the BR200/250 LCD display unit,

follow the steps below to perform a power reset:

1. Un-dock the LCD module from the BR200/250 pistol-grip base

unit.

2. Connect the AC adapter to the LCD module and the appropriate

AC power source.

3. Locate the Reset port on the reverse side of the LCD module

(labeled Reset).

4. Momentarily press the Power Reset button for at least 2 seconds

and then release.

5. Leaving the AC adapter connected to the LCD module, power the

unit on.

6. If the unit powers on, allow it to fully re-charge (up to 2 hours)

before removing AC adapter. If the LCD unit does not power on,

repeat steps 1 through 6.

Specifications

CAMERA

Imaging Sensor CMOS

Total Pixels (NTSC) BR200: 712x486 BR250: 640x480

Horizontal View Angle BR200: 50 degree

BR250: 45 degree

Transmission Frequency 2468MHz

Focus point BR200: 8”(20cm), BR250: 6”(15cm)

Minimum Illumination 0 Lux

Modulation Type FM

Bandwidth 18MHz

Power Supply 4 x AA batteries

Unobstructed Effective Range 10m

Waterproof Capacity IP67 (imager head only)