User manual

AN300‐EU‐ENv1.11/13

SetupMode

EnteringSetupMode

PressandholdtheSETbuttonfor2secondstoenterSetupmode.Twooptionsareavailable:

P1.0:UnitandP2.0:AREA.

Usetheup/downbuttonstotogglebetweenP1.0UNITandP2.0AREAoptions.

P1.0:UnitSelection

1. Onceinsetupmode,attheP1.0UNITdisplay,momentarilypressthe

HOLDbuttontoenter

theP1.0UNITmenu.

2. Usethedown/uparrowbuttonstoswitchbetweenmetricandimperialunits.Theavailable

unitsare:airvelocity(m/s,fpm),temperature(C,F),airvolume(CMM,CFM),andareasize

(cm²,inch²).

3. PressHOLDmomentarilytoreturntotheP1.0

display.

4. PresseitherarrowbuttontomovetotheP2.0AREAoptionandfollowthestepsbelow.

P2.0:AreaSizeSelection

1. Insetupmode,fromtheP2.0AREAdisplay,pressHOLDtoentertheAREAsettingmenu.The

LCDwillshow‘99999’inthelowerdisplaywiththeleft

‐mostdigitflashing.

2. Usetheuparrowbuttonchangetheflashingdigit(from0through9).

3. Usethedownarrow buttontomovetothenextdigit.Usetheuparrowbuttonagainto

changetheflashingdigit.ContinueinthiswayuntilthedesiredAREAvalueis

displayed.

4. PresstheHoldbuttonagainmomentarilytostorethe valueandtoreturntotheP2.0display.

5. PressandholdthePOWERSETbuttonfor2secondstoreturntothenormaloperating

mode.