User Manual

45170 V1.1 5/09

Operation

Turn Power ON

Press the power button to turn power on. The meter will perform a short self-test.

A. Air Velocity Measurements

1. Press the Function button to select the Anemometer mode. In Air Flow mode,

the display will show Air Velocity and Temperature.

2. Press Unit/Zero button to select desired unit of measure (FPM, MPH, KNOT,

KM/H, or M/S) and face the Air Flow Sensor towards the source of wind.

3. Allow time for the reading to stabilize and note value. From a practical point of

view the velocity may fluctuate slightly.

B. Humidity and Ambient Air Temperature Measurements

1. Press the Function button to select RH mode.. In RH mode, the display will

show %RH and Temperature.

2. Press the °C/°F button to select the desired temperature unit of measure.

C. Temperature Measurements Using Type K Thermocouple

1. Press the Function button to select the Temperature mode. In Temperature

mode, the display will show only temperature.

2. Plug the thermocouple into the meter's thermocouple input jack. If no

thermocouple is connected, or if the thermocouple is defective, the meter will

display “

-----

“. (Primary display temperature will only work if a thermocouple

is connected).

D. Light Measurements

1. Press the Function button to select the Light Meter mode . The light values

are displayed and orientated 180° from the other functions for easy use.

2. Press the Lux/Ft-cd to select Lux or Footcandle units of measure.

3. Before making measurements “Zero” the meter out by blocking the light

sensor to simulate a no light condition and pressing the Unit/Zero button.The

reading should go to Zero.

4. Hold the sensor toward the light source and note reading.

MIN, MAX, Data Recording Function

1. Press the Max/Min button once. The RECORD symbol will appear on the

display.This starts the Min/Max Data Recording Mode.

2. Press the Max/Min again and the MAX symbol along with the maximum value will

appear on the display.

3. Press the Max/Min once more and the MIN symbol along with the minimum value

will appear on the display.

4. To Clear the recorded Max/Min values press the HOLD button once. Press and

Hold the Max/Min button for 3 seconds to exit Min/Max Data Record Mode and

return to normal measurement mode. Record and Max/Min will disappear from the

display once this is done.