User Manual

Model 42270/75 42260/65 Version 3.1 December 2004

Software Installation and Operation

Installation

1. Slide the logger onto the RS-232 PC Interface docking station.

2. Connect the PC interface cable to the PC com port (1 or 2).

3. Insert the supplied software disk in the PC CD-ROM drive.

4. The main software screen will appear with the following selections:

• INSTALL SOFTWARE: Click to install the software

• WEBSITE: Visit website

• BROWSE CD-ROM: View all items on the CD-ROM

• EXIT: Close the software

• MANUAL PDF: Open the operation manual in PDF format

Main Software Screen

When the software is run, the window shown in Figure 2 (above) will appear. The window

items are described below. If the PC and Datalogger are not communicating, the following

error message will appear on the lower left hand corner of the software screen.

<<WARNING: Datalogger not plugged into interface module!>>. If this occurs, check the

COM Port settings under the ‘Com Set’ button located on the top row of the software

window.

FIGURE 2

Cursor 1

Cursor 2