User Manual

Version 1.6 7/04
9
Using Windows
TM
Terminal or HyperTerminal program for PC Communication
The Terminal or the HyperTerminal program is included in all Windows
TM
operating systems.
Typically it is located using the following path:
START Menu > Programs > Accessories > Communications > Terminal or HyperTerminal
When in the Terminal or HyperTerminal program, go to PROPERTIES and configure as
follows:
1. In the CONNECT TO field, select COM1 or COM2 (depending on which port is being
used).
2. In the CONFIGURATION section, select the following data format: Baud rate 9600, no
parity, 8 data bits, 1 stop bit, and no flow control.
3. In the ASCII SETUP section, click on “echo typed characters” and “Send line ends with
line feeds”.
After Terminal or HyperTerminal is setup, type in the commands as described in the
previous examples.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX [phone] - TestEquipmentDepot.com