User`s manual

VIR50-EU-EN v2.3 5/14
13
Measurement Settings
From the Video + IR, IR-only, or Dew Point modes, press the ENTER button to access the soft-key
screen. The Measurement Settings mode is represented by the middle icon. Use the arrow buttons
to scroll over to the middle icon (if it is not already highlighted.)
Press the ENTER button again when the middle icon is highlighted to access the Measurement
Settings mode as shown below.
Item Description
Emissivity set Set the emissivity
Alarm High Set the high alarm ON/OFF and set the alarm limit
Alarm Low Set the low alarm ON/OFF and set the alarm limit
Laser Enable or disable the laser pointer
Auto Mode Lock the measurement ON
Max Min Display the highest (MAX) or lowest (MIN) IR temperature
Average DIF Display Average temperature or Differential IR temperature
Ambient TEMP Display the air temperature and relative humidity
Dewpoint Wet Bulb Display the dew-point and wet bulb temperature
Type K Enable or disable the type-k contact thermocouple input
Color Set the color