User Manual

9 UM200-en-GB_V1.6 10/19
Recalling pre-stored Ω/LENGTH data
There are up to 20 pre-stored Resistance per unit values stored into memory. These values can be
recalled and used for cable length measurement.
1. In SETUP mode, press the RECALL button to recall pre-stored data.
2. Press the SELECT button until the resistance per unit values appear.
3. Press the RECALL button to step through the stored values.
4. Turn the rotary switch to the proper range and press START to measure the cable length.
NOTE:
The range of length is 0.0001 ft or m to 9999K ft or m.
When the cable is disconnected, OL Ω is displayed instead of OL FT or m.
When the resistance is 0, 0 Ω is shown instead of 0 FT or m.
If the length is less than 0.0001 feet or meters but greater than 0, 0.0001 feet or meters is shown.
Memory Record, Read and Clear
Record
1. With a reading in the display, press the REC / READ button.
2. The memory location number will flash on the display and the data will be stored to that
location.
Read
1. Turn the rotary switch to SETUP.
2. Press the REC / READ button. The memory will flash and then the data in that location will
be displayed.
3. Press the ▲▼ buttons to scroll through stored data.
Clear
1. Turn the meter off.
2. Press and Hold the REC / READ button and simultaneously turn the meter on.
NOTE:
The memory capacity is 3000 data records. When 3000 records are exceeded, there will be a long
beeping sound and no further data can be recorded..
Backlight
Press the button to turn the backlight on or off.