User guide

9 TM500-EU-EN v1.1 12/13
DataloggingandPCInterface
TypesofDataRecording
 ManualDatalogging:Manuallylogupto99readingsontoanSDcardviapush‐buttonpress.
Thesampleratemustbesetto0toimplementthismode.
 AutomaticDatalogging:AutomaticallylogdataontoanSDmemorycardwherethenumber
ofdatapointsisvirtuallylimitedonlybythecardsize.Readingsareloggedataratespecified
bytheuserfrom1to3600seconds.
 RS‐232/USB:ThemeterincludesanRS‐232/USBPCinterfacejacklocatedonthelowerright
sideofthemeterunderthesnap‐offcompartmentcover.ForstreamingofdatatoaPCvia
theRS232Outputjack,theoptional407001‐USBkit(USBcableanddriverCD)alongwiththe
407001software(availablefreeathttp://www.extech.com/instruments/software.asp)are
required.
SDCardInformation
 InsertanSDcard(from1Gsizeupto16G)intotheSDcardslotatthebottomofthemeter.
Thecardmustbeinsertedwiththefrontofthecard(labelside)facingtowardtherearofthe
meter.
 IftheSDcardisbeingusedfor
thefirsttimeitisrecommendedthatthecardbeformatted
andthelogger’sclocksettoallowforaccuratedate/timestampingduringdatalogging
sessions.RefertotheSetupModesectionforSDcardformattingandtime/datesetting
instructions.
 EuropeanandUSAnumericalformatsdiffer.ThedataontheSDcardcanbeformattedfor
eitherformat.ThemeterdefaultstoUSAmodewhereadecimalpointisusedtoseparate
unitsfromtenths,i.e.20.00.TheEuropeanformatusesacomma,i.e.20,00.Tochangethis
setting,refertotheSetupModesection.
ManualDatalogging
InthemanualmodetheuserpressestheLOGbuttontomanuallylogareadingontotheSDcard.
1. Setthesamplingrateto‘0’secondsasdescribedinthe SetupModesection.
2. PressRECbuttontoturnonmanualrecordmode.TheRECiconwillappearinthe
upper
leftcornerofthedisplay.Thelowerportionofthedisplaywillshowp‐n(n=memory
positionnumber1‐99).
3. PresstheENTERbuttonmomentarilytologareadingintomemory.TheLOGGERiconwill
flasheachtimeadatapointisstored(theSCANSD
iconwillappearwhenthemeter
accessesthecard).
4. Advancetothenextmemorylocationusingtheuparrow▲button.
5. Toexitthemanualdataloggingmode,pressandholdtheRECbuttonforatleast1.5
seconds.