User guide

6 TM500-EU-EN v1.1 12/13
SettheTemperatureUnitsofMeasure(°Cor°F)
1. Accessthet‐CFparameter.
2. Usethearrowbuttonstoselect°Cor°F.PressENTERtoconfirmsetting.
3. PresstheENTERbuttontoexittotheSetupmode.PressESCtoexitsetupmode.
SettingtheDataloggerSamplingTime(Rate)
1. AccesstheSP‐tparameter.
2. Usethearrowbuttonstoselectthedesiredsamplingrate.Theavailablesettingsare: 0,1,2,
5,10,30,60,120,300,600,1800,and3600seconds.Use‘0’ formanuallogg ingmode.A
samplingrate>1secondisrecommended. 
3.
PresstheENTERbuttontoconfirmtheentry. 
4. PresstheENTERbuttontoexittotheSetupmode.PressESCtoexitsetupmode.
SDCardFORMATTING
1. AccesstheSdFparameter.
2. UsethearrowbuttonstoselectYEStoformatthecard(selectNOtoabort).Notethatall
dataonthecardwillbelostifformattingisattempted.
3. PressENTERtoconfirmselection.
4. PressENTERagaintore‐confirm.
5. Press
theENTERbuttontoexittotheSetupmode.PressESCtoexitsetupmode.
  Note:alwaysformatanewSDmemorycardbeforeuse.