User Manual

2. If the Notes option is set to Always then the

thickness reading is stored at the ID location

[Linear], [Row], [Col] with notes. To change the

Notes settings, select the Notes option from the

Datalogger screen in the MAIN Menu.

Now when you press Save T (T for Thickness)

to store a reading in measurement mode, the

following Notes options will be presented:

No comments, not sand blasted, pitting, too hot, broken

insulation, couldn’t read scaffold, needs painting,

broken/missed plug, obstruction, port,

burner,

metalized, overlay, already cut out, and pad weld

3. Use the up and down arrow keys to select a

note for the reading and press the OK key. The

selected note will be stored at the ID location,

and based on the file type, [Linear], [Row], or

[Col] is incremented. (See: Directory selection

for file type details.)