User Manual

Battery Replacement
If the instrument does not switch on, displays the low battery symbol, or if the Battery
Check yields less than 44% on the wood moisture scale, replace the batteries as follows:
1. Remove the Phillips head screw from the belt clip/battery compartment located
on the rear of the instrument.
2. Remove the batteries taking note of their orientation and polarity.
3. Install three (3) new CR-2032 button batteries observing polarity.
4. Secure the battery compartment with the Phillips head screw.
Electrode Pin Replacement
To replace the two electrode pins:
1. Remove the protective cap
2. Unscrew the electrode pins
3. Install the new pins
4. Replace the protective cap
Maintenance
• Always keep the instrument dry
• Prevent dirt from accumulating at the electrode pins
99 Washington Street
Melrose, MA 02176
Phone [phone]
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Back to the Extech MO210 Product Info Page
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX [phone] - TestEquipmentDepot.com