Instruction manual

8 382860 Ver. 1.5 2/01

• MEM (Memory): Up to 10 measurements (0 to 9) can be stored and recalled.

Press the FUNCTION key five times then press the SET/RESET key once to store

the present measurement value in the first available memory location. The memory

location number will flash to the upper left of the left-most sub-LCD. The

memorized reading is shown on the center sub-LCD. Use the UP/DOWN keys to

scroll to the next free memory location. Take another measurement and press the

SET/RESET key to store it. If a memory location number which has been used

before is selected, the previous value is updated (erased) with the new

measurement value. If you accidentally exit the function mode by pressing the

SET/RESET key too many times, the memory is not erased. It can be “recalled”

using the RECALL function which follows…

• RCL(Recall): This function recalls memorized readings to the LCD. Press the

FUNCTION key 6 times until the RCL icon flashes. Press the SET/RESET key

once. The memory location reference number flashes to the upper left of the left-

most sub-LCD. Press the UP or Down keys to select a memory address (a number

from 0-9 where the measurement has been stored). Press the SET/RESET key

again to recall the reading memorized in the selected location. The recalled value

(ref. No. 0) will appear on the left sub-display; the 2

recalled value (ref. No. 1)

appears on the center sub-display and the 3

recalled value (ref. No. 2) appears on

the right side sub-display, and so on for the remaining locations.

• CMP (Comparison): Comparison mode allows readings to be compared to user

programmable High/Low setpoints. Press the FUNCTION key and then the DOWN

key. Press the SET/RESET key once and the word “LOW” should begin flashing

above the left-most sub-LCD. Press the SET/RESET to begin editing the LOW user

setpoint. Use the SET/RESET key to move from digit to digit and use the

UP/DOWN keys to change a digit’s value. When done, press the SET/RESET key

until the LOW setpoint value ceases flashing. The word “HIGH” will begin flashing

over the right-most sub-LCD. Edit the HIGH setpoint in the same manner as the

LOW setpoint. After both reference values have been defined press the

SET/RESET key again. The R-H (Range Hold) icon will begin flashing. Set the

measurement range via the UP/DOWN keys. On the center sub-display “LO”

appears for readings less than the low reference value, “Hi” is displayed for

readings higher than the highest reference value, and “Pass” is displayed for

readings in the region between the low and high reference values. To exit CMP

mode, press the FUNCTION key.

• AUTO-POWER-OFF extends the life of the battery: if neither the rotary function

switch nor any button is operated for 12 minutes the DMM is automatically turned

off. During active “communication” of the multimeter with a PC, AUTO-POWER-

OFF is disabled.