User Manual

IR267‐en‐US_v1.21/17

Operation

MeterPower

Themeterispoweredbyone9Vbatterylocatedinthemeterhandle.RefertotheMaintenance

sectionforreplacementinstructions.Thedisplayedbatteryiconprovidesbatterystatus.Replace

thebatteryassoonasthebatterystatusiconflashes.

Non‐ContactIRSurfaceTemperatureMeasurements

TheIR267thermometerremotelymeasuresthesurfacetemperatureofanobject.Theemissivity

mustbeproperlysettoobtainoptimumaccuracy(seetheEmissivitysectionfordetails).

1. Holdthemeterbythehandlegripandpull(andhold)thetriggertopowerthemeter.Use

thearrowbuttontoselecttheO(object/surface)modeifnecessary.Scanthesurfacesunder

test;thesymbolS(scan)blinkswhilescanning.RefertotheFieldofViewsectionfor

distance‐to‐target(spot)ratioconside rations.

2. Aimthelaserpointerapproximatelyahalfinchbelowaspecificpointofinterest.

3. ReleasetheTrigger;thesymbolHwillappearandthereading (largerdigitsatcenterof

display)willholdfor10seconds,afterwhichthemeterwillautomaticallyshutoff.

4. Notethatthesmallerdigits,lowerright,reflect theMIN‐MAX‐AVGorDIFreadingasselected

inthe

Settingsmode.

5. ThemeterdefaultstothesettingsinusewhenthemeterwaslastswitchedOFF.

Ambient(Air)TemperatureMeasurements

TheIR267canmeasurethetemperatureofambientairusingtherecessedtemperaturesensor

locatedonthefrontofthemeternexttothelaserpointerlens.

1. PullandholdtheTriggertokeepthemeterpowered.

2. UsetheUPorDOWNbuttontoselecttheA(ambient)mode.



3. Holdthemeterbyitshandlegripintheambientair.

4. Whenfinished,releasetheTrigger;thesymbolHwillappearandtheambientair

temperaturereadingwillholdfor10seconds.

ContactThermocouple(Type‐K)TemperatureMeasurements 

Toavoidelectricalshockorpersonalinjury,donotconnecttheexternalprobetolive

electricalcircuits.

1. PlugtheType‐Kthermocouplesensorintothesub‐miniaturejacksatthebottomofthe

instrument(oneplugspadeiswiderthantheother).

2. Pullthetriggertopowerthemeter.

Holdthetriggertokeepthemeterpowered.

3. UsethearrowbuttonstoselecttheK(thermocouple)mode.

4. Holdthethermocoupleinairortouchthetipofthethermocoupletoanobject’ssurface.The

thermocoupletemperaturemeasurementwillbedisplayed.

5. Whenfinished,releasetheTrigger;thesymbolHwillappearandthethermocouple

temperaturereadingwillholdfor10seconds.