User Manual

ManualsBrandsExtech Instruments ManualsKitchenNon-Contact Forehead IR Thermometer

User Manual

Non-contact Forehead IR Thermometer

Model IR200

Additional User Manual Translations available at www.extech.com

Important: Do not use rechargeable

batteries in this device. Ensure that

batteries are installed in the proper

polarity orientation before use.

Failure to observe these precautions

can result in product overheating.

Summary of content (7 pages)

PAGE 1
User Manual Non-contact Forehead IR Thermometer Model IR200 Important: Do not use rechargeable batteries in this device. Ensure that batteries are installed in the proper polarity orientation before use. Failure to observe these precautions can result in product overheating. Additional User Manual Translations available at www.extech.
PAGE 2
Introduction Congratulations on your purchase of the Model IR200 IR Thermometer. This thermometer is intended for scanning groups of individuals or monitoring an individual for elevated temperatures. It is not a substitute for a clinical thermometer. Always use a clinical thermometer when high accuracy body temperature measurements are required. Considerations and Warnings Read all instructions before using this product. Do not use rechargeable batteries in this device.
PAGE 3
Meter Description 1. IR sensor 2. Body/Surface switch 3. ▼ button 4. ▲ button 5. MODE button 6. Measurement trigger 7. LCD display 8. Battery compartment DISPLAY 1. Surface mode 2. Body mode 3. Temperature display 4. Memory location 5. Alarm active 6. Temperature units 7. Low battery icon 8. Memory temperature display 3 IR200-en-GB_V1.
PAGE 4
Operating Instructions Body Temperature Measurements 1. Set the Body-Surface- switch for “Body” for accurate measurements in the range of 32.0 to 42.5°C (89.6.0 to 108.5°F). 2. Hold the meter by its handle and point it toward the surface to be measured. Measurement distance should be 5 to 15cm (2 to 6”). 3. Press the trigger to turn the meter on and take a temperature reading. The temperature reading appears in the large display and the logged data number and value appear in the smaller display. 4.
PAGE 5
Surface Temperature Mode settings 1. With the meter OFF, press the MODE button once to set the C/F temperature units. The temperature units will flash. Press the ▲or ▼ buttons to change the units. 2. Press the MODE button a second time to set the alarm temperature limit. Press the ▲or ▼ buttons to change the value. 3. Press the MODE button a third time to set the alarm buzzer status. Press the ▲or ▼ buttons to switch from ON to OFF. Data memory The meter can store up to 32 readings in the memory.
PAGE 6
IR200 Thermometer Cleaning Instructions The IR200 Non-Contact Forehead IR Thermometer is a non-critical Reusable Medical Equipment (RME) device. Please clean and disinfect the housing and lens of this device before and after each use. To clean and disinfect this device please read and understand these instructions. Equipment Required Please obtain Isopropyl Alcohol or a mild antiseptic solution (70% alcohol concentration or higher) and low-lint soft cloths or cotton swabs.
PAGE 7
Specifications Range Body Temp Surface Temp Accuracy 32.0 to 42.5°C (89.6 to 108.5°F) ° ° 0 to 60 C (32.0 to 140 F) ±0.3°C/0.5°F ±0.8°C/1.5°F Emissivity 0.95 fixed Field of View D/S = Approx.