Datasheet

HDV-WTX1-EU-EN V2.2 4/13

Articulation Setup and Orientation

The articulation direction and orientation may change if the probe is twisted and coiled during

use or when stored. To re-orient the probe:

1. Place the extended probe on a flat surface

2. Set the tension “F” knob to the left or released position.

3. Set the articulation knob to the center position with the R Δ and Δ L

labels in the horizontal position.

4. Manually adjust the probe and camera to the zero degree position.

5. Rotate the articulation knob clockwise for a 90° bend.

6. If necessary, manually adjust the probe so that the camera lays flat on

the surface with a 90° articulation

7. Rotate the articulation knob counter-clockwise and confirm proper

orientation.

Charging the Battery

The AC charger port and charging status LED are located in the bottom access compartment.

Connect the charger to the probe and observe the color of the LED. Red indicates the battery is

charging. Green indicates the battery is fully charged.

Note: The rechargeable battery is not user replaceable.

Specifications

Resolution 640 x 480 pixels

Length 1m (3.3’)

Outer diameter (O.D.) 6mm (0.24”)

Battery 3.7V rechargeable Li-Polymer

Focus distance 2 to 6cm (0.79 to 2.36”)

Housing Stainless Steel

Field of View 60°

Number of LEDs 4

Lamp Output 3500 Lux at 20mm

Operating Temperature -20 to 70°C (-4 to 158°F)

Storage Temperature -20 to 70°C (-4 to 158°F)

Warranty 1 year

ISO-9001 Certified