Datasheet

Informational sheet
Model HDV-WTX
Wireless Transmitter
For use with the HDV600 Borescope only
The wireless transmitter is intended for use in areas that are difficult to access or
in situations when is hard to maneuver the probe with the display attached. The
probe can also be connected directly to the monitor using the patch cord.
Note: The battery must be fully charged for wireless operation. A weak battery
may result in meter shut down.
Wireless Mode
1. Connect the AC adaptor to the transmitter and charge the
battery.
2. Attach the probe to the transmitter.
3. Press and hold the Power button for 4 seconds to turn the
monitor on, then select “WIRELESS” under the INPUT SOURCE selection
in the MENU screen.
4. Press and hold the Power button for 4 seconds to turn the transmitter on.
The camera video will be transmitter to the monitor display.
Direct Mode
1. Connect the AC adaptor to the transmitter and charge the
battery.
2. Attach the probe to the transmitter.
3. Connect the patch cord between the transmitter and the
monitor probe input connector
4. Press and hold the Power button for 4 seconds to turn the transmitter on.
5. Press and hold the Power button for 4 seconds to turn the monitor on, then
select “DIRECT” under the INPUT SOURCE selection in the MENU screen.
6. In the direct mode, light intensity is controled by the buttons on the monitor,
not by the buttons on the transmitter.
This is product is warranted for one year.
Copyright © 2011 Extech Instruments Corporation (a FLIR company)
All rights reserved including the right of reproduction in whole or in part in any form.
www.extech.com
Revision 1.0 6/11