User Manual

EX36x‐en‐GB_V1.61/17

Non‐ContactVoltageDetector

WARNING:Itispossibleforvoltagetobepresentinacircuitevenifthemeterdoesnot

beeporlighttheNCVLEDlampatthetopofthemeter.Alwaysverifymeteroperationona

knownliveACcurrentcircuitandverifythatthebatteriesarefreshbeforeuse.

The audible beeper sounds and the LED lamp at the top of the meter lights when the meter

sensesanelectricalvoltagefield.

IfthemeterdoesnotemitatoneorlighttheLEDinthismode,thereis still the  possibilitythat

voltageispresent.Pleaseusecaution.

Turn the function switch to the NCV position to access the Non ‐Contact Voltage Detect

mode.

2. Use the  Lo/Hi button to select low sensitivity (160 to 1000V) or high sensitivity (80 to

1000V).ThedisplaywillshowLoforlowsensitivityorHiforhighsensitivitymode.

3. Notethevoltagedetectiondisplayicon onthedisplaywheninthismode.

4. To test, place the meternear asourceof electricalenergy. Notethat thetip ofthe meter

offersthehighestsensitivity.

5. NotetheaudibletoneandtheLEDlightwhenasourceofelectricalenergyisdetected.



Fig4‐5NON‐CONTACTVOLTAGEDETECTOR

