User Manual

EN-US English

• Mirror accessory

• Attachment fixture

1.4 OPERATION

1.4.1 Battery Installation

The BR90 is powered by four 1.5V AA batteries. To install the batteries, open

the rear battery compartment using the latches as shown Figure 2 (item 1).

Observe correct polarity when installing batteries. Ensure that the battery

compartment is completely closed before use. The battery status indicator ap-

pears on the upper left corner of the video monitor for convenience.

Figure 1.2 Opening tabs for battery compartment (1) and cable storage (2).

Never dispose of used batteries or rechargeable batteries in house-

hold waste. As consumers, users are legally required to take used batteries to

appropriate collection sites, the retail store where the batteries were pur-

chased, or wherever batteries are sold.

1.4.2 Powering the BR90

To switch the BR90 ON, long press the Power ON/OFF button (top, right) until

the power indicator lamp lights. Long press again to switch OFF.

1.4.3 Accessing the Camera Cable

The camera cable is stored in the BR90 housing. To access the cable, press

the two compartment tabs, as shown in Figure 2 (item 2). Release a length of

#NAS100023; r. AC/63396/63396; en-GB