User`s guide

42582-EN v6.1 07/13

To edit the fields in datalogger SETUP Screen1:

1. Use the up and down arrow keys to scroll through the parameters.

2. When a parameter is highlighted, use the F2 EDIT softkey to open it for editing.

3. Use the alphanumeric keypad to edit the parameter.

4. Press the F4 ENTER softkey to save changes. Press F1 ABORT to cancel changes.

5. Press the F1 EXIT softkey to return to the SETUP screen.

Recording Data in the Automatic Datalogging Mode

1. After configuring the datalogger using the SETUP screen as described previously, place the

meter in position to take readings (a tripod mount is provided on the rear of the instrument

for convenience).

2. Press F3 LOG from the WELCOME screen and then press F2 START.

3. Recording will begin on the date and time programmed at the BEGIN and START lines in

the SETUP screen.

4. The Datalogger will record everyday from the START time to the SUSPEND time. The last

day that datalogging will take place is the date programmed in the END line.

5. When the logging begins, the screen should indicate LOGGING...

6. If the screen does not indicate logging at the programmed start time, make sure the START

key is pressed. Also check the section below entitled “Automatic Datalogging START and

END date considerations” for troubleshooting.

7. To stop logging before the programmed SUSPEND time, press the F1 STOP softkey.

8. While logging, view data records by pressing F4 VIEW.

9. To print data from the list, press the F1 STOP, the F4 NEXT and then press the F3 PRN

softkey. Press the F2 YES softkey when the PRINT? display appears.

10. To clear (erase) the recorded data, access the LOG mode from the WELCOME screen.

Select SET, NEXT and then press and hold the CLR (clear) softkey until the display prompts

for confirmation. Select YES to delete all records, or NO to abort the clearing process.

Automatic Datalogging START and END Date Considerations

1. If the START date is set to a date before the current date, the datalogger will start the

moment the START softkey is pressed.

2. The datalogger will not start logging if the END date is earlier than the current date.