User Manual

42570-en-GB_V1.7 10/16
6
Data Logger
Storing Data: The thermometer is capable of storing up to 100 data points.
Infrared: To store data from an infrared reading,
1. Pull and Hold the trigger
2. Press the MODE button until LOG appears in the lower left corner of the display; a log
location number will be displayed. If no temperature has been recorded in the displayed
LOG location, 4 dashes will appear in the lower right corner.
3. Aim the unit at the target area you want to record, and press the laser/backlight button. The
recorded temperature will appear in the lower right corner.
4. To select another log location, press the up and down keys.
Recalling Data: To recall stored data after the unit shuts off,
1. Press the MODE button until LOG appears in the lower left corner. A LOG location number
will be shown below LOG, and the stored temperature for that location will be display.
2. To move to another LOG location, press the UP and Down keys.
Log Clear Function: To clear the memory,
The “Log clear” function allows you to quickly clear all logged data points. This function can only
be used when the unit is in the LOG mode.
1. While in LOG mode, press the trigger, and then press the “down” arrow button until LOG
location “0” is displayed. Note: This can only be done when the trigger is pulled. LOG
location “0”cannot be accessed, by using the “up” arrow button.
2. When LOG location “0” shows in the display, press and release the laser/backlight button,
then press and release the up arrow key. A tone will sound, and the LOG location will
automatically change to “1”, signifying that all data locations have been cleared.