User`s guide
Table Of Contents
- User's Guide
- Resolution
- DC Voltage
- AC Voltage
- Resistance
- Power Measurements
- Attention: Transistor, capacitance and temperature measureme
- Input Terminals
- Transistor Socket hFE (PNP NPN)
- Attention: Never exceed the maximum input limits (1000VDC
- AC / DC Voltage Displays
- Attention: Never measure current in circuits where over 250
- Attention: Make sure all objects, circuits and components un
- Attention: During diode tests, ensure that components and ci
- Attention: Observe the max. input limits. Never connect volt
- POWER MEASUREMENTS
- Software for PC Interface
- Using the DOS Software
- Input Terminals
18 382860 Ver. 2.1 09/04
PC INTERFACE
Hardware Setup
Connect the supplied RS-232C cable between the meter’s com port and the computer’s
serial port. Power the meter and the computer and then load the software.
Software for PC Interface
Two data acquisition programs are included: a DOS version (ScopeView) and a
Windows version (MultiView).
Using the DOS Software
Follow these steps to install and run the MS-DOS software.
1. Insert the supplied diskette in your computer’s 3 ½-inch floppy drive.
2. Create a directory on your hard disk . For example, to make a directory
called METER type.: cd \ (ENTER) then, type md METER (ENTER)
3. Change to the directory you just created. For example, if the directory is
METER, type: cd \ METER (ENTER)
4. Copy the files from the GRAPHIC sub-directory on the supplied program
floppy disk to your hard disk. For example, type: copy a:\GRAPHIC c:
5. To run the program, type METEX (ENTER) Follow the on-screen help for
specific operating instructions.
Using the Windows Software
Follow these steps to install and run the Windows software
Note: The following steps assume a basic knowledge of Microsoft Windows. This
software requires Microsoft Windows 95/98.
1. Start your computer and run Windows.
2. Insert the supplied diskette in your computer’s 3 ½-inch floppy drive.
3. For Windows 95/98, choose RUN from the START menu.
4. At the prompt, type:
5. a:\scope\setup (ENTER) (if you placed the diskette in Drive A) or
b:\scope=setup(ENTER) (if you placed the diskette in Drive B)
6. Follow the on-screen prompts to complete the installation.
7. To run the program, double-click the SCOPE-VIEW icon, Follow the on-
screen help for specific operation instruction. Also, refer to the README file
in the diskette’s SCOPE subdirectory for operation hints.