User`s guide
Table Of Contents
- User's Guide
- Resolution
- DC Voltage
- AC Voltage
- Resistance
- Power Measurements
- Attention: Transistor, capacitance and temperature measureme
- Input Terminals
- Transistor Socket hFE (PNP NPN)
- Attention: Never exceed the maximum input limits (1000VDC
- AC / DC Voltage Displays
- Attention: Never measure current in circuits where over 250
- Attention: Make sure all objects, circuits and components un
- Attention: During diode tests, ensure that components and ci
- Attention: Observe the max. input limits. Never connect volt
- POWER MEASUREMENTS
- Software for PC Interface
- Using the DOS Software
- Input Terminals
16 382860 Ver. 2.1 09/04
Storing and Clearing Accumulated Measurement Data
The meter memorizes accumulated reading data when the POWER position of the
Rotary Switch has been changed to another function after Power measurements
have been made (this activates the memory utility). To recall accumulated data, re-
select POWER on the Rotary Switch, the meter displays stored data in EEPROM.
To clear accumulated readings: Set the Cost per KW/H to 0000.0 in mode 2 (left
sub-LCD display).
General Power Measurement Notes:
1. When POWER is selected via the Rotary Switch, automatic power-down
works only when the watt measurement reading is zero.
2. When POWER is selected on the Rotary Switch, the FUNCTION key will not
operate when pressed.
3. To save (store) the cost per hour, KW/H, and accumulated cost data, press
the FUNCTION key or turn the Rotary Switch to another range AFTER
DISCONNECTING THE POWER ADAPTOR. Never change the Rotary
Switch setting from POWER with the Adaptor connected. Serious injury and
meter damage can result.
4. The meter always memorizes the last input values of cost per hour, KW/H,
and accumulated costs that were measured.