Specifications

382275/6-EU-EN v4.3 3/14
9
RemoteControlMethodA:UsingtwoexternalvariableDCvoltagesources
Avariableexternalvoltagesourceof0~5VDCisfedintotheremotecontrolterminaltoadjust
theoutputvoltagelevel.
Warning! Donotinputvoltagehigherthan5V,otherwisetheOverVoltageProtection(OVP)
willbetriggered. 
1. Ensurethattheload isdisconnectedandthatthepowersupplyisOFF. 
2. UseONLYthewiresfromPort2(Positive)andPort4(Negative)
3. Switchonthepowersupply.
4. Varytheexternalinputvoltage0~5Vtocheckandverifythefulloutput voltage
rangeofthesupply.
5.
Shortthemainoutputwith10AWGwiretochecktheCCdisplay byvaryingthe
externalvoltagesource.
6. SwitchOFFthepowersupply.

RemoteSocketPINassignmentfor externalvariablevoltagesource
PIN FUNCTION NOTES
1 Internal+5VDC 50mAmaximum
2 VoltageAdjustment 0to5V
3 CurrentAdjustment 0to5V
4 Ground
5 OutputOFF Shorttoground
6 Unused
7 Unused
8 Unused



