Specifications

382275/6-EU-EN v4.3 3/14
5
PresetMode
InthePRES ETmode,theRearControlLightisswi tchedONtoindicatethatthepanelvoltage
andcurre ntcontrolsarede‐activated.
Therearethreepresetoutputs,P1,P2andP3,selectableviatheReca ll Switch,locatedonthe
rearofthepower supply.
Thepresetvaluesarefactoryset
perthefollowingtable.

Presets OutputVoltage OutputCurrent
P1 5V Maximum
P2 13.8V Maximum
P3 25V Maximum

SetMode
IntheSETmode,theVoltageandtheCurrentvaluesforthethreepresets(P1,P2,andP3)ca n 
beprogrammed.
1.
SettheMo deSwitchlocatedontherearof thepower supplytothe“SET”posit ion.
2.
SelectapresetusingtheRecallSwitch(settotheP1,P2orP3posi tion) .
3.
UsethefrontpanelVoltageContr o lKnobtosetthedesire dvoltageva lue .
4.
UsethefrontpanelCurrentControlKnobto setthedesire d currentva lue .
5.
Repeatthisprocedurefor theremainingpresetsifdesired.
6.
MovetheRecallSwitchfromtheSETtothePRESETpositiontostore changes.
Note: Presetsresideinnon‐volatilememorymeaningthatthevoltageandcurrentsettingsfor
eachpresetareretainedevenwhenthepowersupplyisswitchedOFF.

Caution:ChecktheoutputvoltageofthepresetinusebeforeconnectingtotheLoad.Tochecka
presetvalue,movetheModeSwitchtothePRESETpositionandthenmovetheRecallSwitchto
theP1,P2orP3position.The VoltageandCurrentsettingsforthecorrespondingpresetwill

display.