Installation Instruction Manual

Extang Corporation, 5400 S. State Rd., Ann Arbor MI 48108, 734-677-0444, Fax: [phone]
Visit us at:
extang.com
6
Insert side
rail clamp
all the way
into rail.
Insert side rail clamp all the way into rail.
Note: For over-the-rail bed liners refer to
Diagrams A and B below.
Insert bow onto top or bottom peg.
(Top peg for performance, Bottom for good
looks.)
Ends are spring loaded
for easy installation.
Push and hold on
spring end and let the
other end slide on with
the spring action.
SPECIAL
FEATURE:
Two pegs
offer two
height
adjustments.
Note:
Bow End does not
fit between pegs.
For each clamp mark on your bedliner a 1-1/2” x 3”
hole as shown above. Remove clamp. Cut holes in
bedliner. Reinsert side rail clamp. Return to step 5.
Side rail clamped to bed
with bow attached.
A
87
STANDARD CLAMP
IMPORT CLAMP
Clamp Spacing (Same for each side)
See the stickers located on each side
rail for clamp position, or refer to the
dimensions given below.
Note: Remove stickers
after installation.
B
Longer Clamps
Some trucks use two lengths of
bracket to fit sculpted sidewalls.
Longer clamps go in the
forwardmost (Cab) positions
while the shorter pair hold the
rails at the rear (tailgate) end.
5
9
EASY USE OF TRUCK BED
Tarp may be rolled up and secured
with Velcro® for bulk hauling
A. Release lever on both corners
of tailgate rail and tilt rail up.
D. Finish attaching tarp along each side by
pushing down and sliding you hand towards
each corner. You can feel the “grip” action.
C. Close-up of downward rotation of
rear rail. You will feel the “snap” effect
and see it tighten snugly.
PUSH
DOWN
PRESS & SLIDE
YOUR HAND
B. Attach tarp at front by
pressing down on edge of tarp
with the palms of your hands
(about only 12 inches on each
side). Then hook tarp to the tails
railʼs groove and click down to
tighten tarp. See close-up.
DIAGRAM
Upper
Peg
Lower
Peg
Do Not
Place
Between
the Pegs
For an OVER-THE-RAIL Bedliner
DIAGRAM
LONGBED (4 clamps)
SHORTBED (3 clamps)
Short Clamps
Long Clamps
Short Clamp
Long
Clamps
FOR INSTALLATION
IN THE FOLLOWING
TRUCK MODELS:
Ford HD Long-Bed
Ford HD Short-Bed
Place Clamp
Here
STICKER
Place assembly
over truck box. Center
between cab and tailgate.
Off the truck bed,
connect the end rails
to the two side rails.