Installation Manual

Slide two of the rail brackets into each rail.

Align with the rail interior prole as shown.

Truck Hero, Inc., 5400 S. State Road, Ann Arbor, MI 48108

Visit us at truck-hero.com

Slide one rail bracket to the front, leaving

the other at the tailgate end of the rail.

(Notch is at the

tailgate end)

With the rail brackets slid into the rails, assemble the brackets as shown. Loosely tighten the screws.

Mounting Rail Left (driver)

Rail front, copied on left (driver) and right (passenger)

Tap Plate

Rail Bracket

Rail

Bracket

Screws

Front (cab) bracket

(notice the slotted holes are on the top)

Rear (tailgate) Bracket Left Rear (tailgate) Bracket Right

Mounting Rail Right (passenger)

Tap Plate

With the brackets mounted to the rails, place the rails on the truck. Position the rail so the front

cap pad rmly contacts the bulkhead. Align the brackets so that they line up with the

factory tie-down hook bolt holes, then thread in the factory bolts and tighten.

Tighten the front hardware while pushing down on the rail to make good seal contact

with the truck bed at the same time also pushing the rail forward to keep good

contact between the cap pad and bulkhead.

Continue to push down on the rail while tightening

the rear bracket hardware.

Cap pad

to bulkhead

Tighten both Torx bolts,

then tighten both

Allen head bolts.

Tighten both Torx bolts,

then tighten both Allen

head bolts.

Push down

REFER TO TRUCK BED COVER INSTALLATION SHEET FOR NEXT STEPS