Installation Manual

Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks.

I t e m N o . 3 1 8 3 0 0 0 4 - 3 0 - 1 6 1 0 DD

5400 S. State Road

Ann Arbor, MI 48108

Truck Hero, Inc., 2016 Printed in U.S.A.

2017 Honda Ridgeline Mounting Rails

INSTALLATION INSTRUCTIONS

T50 Torx driver

7/16” Wrench

Tools Required:

Front, upper tie-down hooks.

Both sides.

Rear, upper tie-down hooks.

Both sides.

Universal Kit # S21001010. Align the parts for assembly as shown.

truck-hero.com

3 1 8 3 0 0 0 4 - 3 0

Rear (tailgate)

Bracket Right,

(Notch is at the

tailgate end)

Rear (tailgate) Bracket Left

Mounting Rail Left (driver)

Mounting Rail Right (passenger)

Screws, 1/4-20 x 3/4LG S.H.C.S

Rail Bracket

Front (cab) Bracket

(notice the slotted holes are on the top)

Tap Plate

IMPORTANT- INSTALL THESE RAILS FIRST

PAGE 1
IMPORTANT- INSTALL THESE RAILS FIRST INSTALLATION INSTRUCTIONS 2017 Honda Ridgeline Mounting Rails Tools Required: T50 Torx driver 7/16” Wrench Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks. Front, upper tie-down hooks. Both sides. Rear, upper tie-down hooks. Both sides. Universal Kit # S21001010. Align the parts for assembly as shown. Rear (tailgate) Bracket Right, Mounting Rail Right (passenger) (Notch is at the tailgate end) Screws, 1/4-20 x 3/4LG S.H.
PAGE 2
Slide two of the rail brackets into each rail. Align with the rail interior prole as shown. Slide one rail bracket to the front, leaving the other at the tailgate end of the rail. (Notch is at the tailgate end) With the rail brackets slid into the rails, assemble the brackets as shown. Loosely tighten the screws.