Installation Manual

For bed caps, trim only enough of the
bed cap edge so the rear (tailgate) clamp
contacts the bottom of the metal ange.
For bed liners that cover the metal ange,
trim a minimum of 100 mm or 4” of the
liner wall so the clamps contact the bottom
of the metal ange.
100mm
4.0”
If your truck has a bed cap or
bedliner that covers the metal
bed wall ange, you will need
to remove enough so that all
the clamps make solid contact.
With the tailgate open and the
front (cab) clamps secure, completely
close the cover.
Slide the rear (tailgate)
clamp at an angle to
the truck bed rail.
Pull the clamp down
and swing it under
the truck bed rail edge.
The spring loaded clamp
will lock under the truck
bed rail edge.
The front (cab) clamp stows in the
cover rail. Rotate the clamp
down and slide it towards the bed rail.
Rotate the body
of the clamp up
or down to match
it’s position with the bed rail ange.
Swing the
clamp vertically and align the
clamp jaw under the metal
truck bed flange.
Tighten the T-handle by hand.
Do not use a wrench.
Position the
clamp body
so that bottom
of the ridges
match the
bottom of the
metal ange.
To aid in better water management
and the straight appearance of the cover,
push down on the cover to compress the
seals while tightening the clamps.