Installation Manual
10
EASY USE OF TRUCK BED
Tarp may be rolled up and secured with buckle
straps for bulk hauling. For more access, tarp can
also be removed completely by loosening T-knobs.
12
Seal the tonno by pressing
the velcro© fastening strips
from the cab end and press
all the way back.
Before using any commercial car wash, push down
both sides of the Velcro© strips. This will reduce
the possibility of water entering the truck bed.
Over time, the velcro might develop a fuzzy
appearance. This is normal and will increase the
holding strength.
For care instructions see tag on underside of tarp
6
8
11
Insert tail rail into the
tailgate block and
rotate it down to the
spring lever. Tarp is
self-tensioning.
To release tarp, push
down on spring lever.
Bows can be
detached from the
underside of the Tarp.
7
9
Extang Corporation, 5400 S. State Road, Ann Arbor, MI 48108, 734 677-0444, Fax: 734 677-8409
extang.com
Engage the narrow edge of the cab rail to the pivot blocks and rotate the
rail down while pulling the cabrail back against the pivot block.
IMPORTANT: If tarp touches toolbox, move side rails back.
Slide the slide blocks outward
so that they engage the wide flange of the side
rail and secure the knurled knobs to tighten.
Unroll your tarp from the cab rail to the
tailgate. The tonno bows are deployed as
the tarp is unrolled.
If needed, you can adjust the
alignment of the tailgate rail by
changing the tailgate strap positions.
Prior to driving vehicle make sure both slide
locks at cab rail are secure.
Lay assembled tonno into truckbed
over L channel.
Insert
U-clamp into
the side rail.
Tighten bolts with small
Allen wrench provided. Repeat
steps 3 and 4 for the other rail.
Tighten clamp
bolts to hold rail
in place.