Specifications

eSATA3 Express Card /34mm
3
4. Installing eSATA cables
There are two eSATA3 connectors which are double-decked on
this Express card. The lower one is port #0 and the upper one is
port #1. To connect the eSATA devices, use an eSATA-to-eSATA
cable (since the cable does NOT support bus power, the eSATA
device has to be self-powered). Since it is a point-to-point
connection, no termination problem has to be cared about.
To install the device drivers, insert the supplied driver CD (folders as
the following picture).
Please follow the following steps:
1. Run the driver installer (drvSetup.exe) in the folder
\SATA3\88SE9128\Drivers to install the drivers
2. Reboot the system to let the drivers take effect.
4. Driver Installation