Operation Manual

8 9
without soft tip around it) between your
ngers and pull it out of the soft tip.
6
Placing Qleaf Go in the ear
I Put the end of the soft tip with the
dome(s) loosely in the ear. The pull cord is
situated behind the tragus, directing
towards the nose.
II Insert the device into the ear by pressing on
the at side of the device. Now gently push
the device deeper into the ear. If the mouth
is opened wide, insertion will be easier.
Ideally, the outside of the module (the part of
the module which is not covered by the soft
tip) will be positioned at the entry of the ear
canal after insertion. In this way, the device is
practically invisible and the sound optimal.
There are cases where the ear canal is too
small. In that case, it is possible for the device
to protrude a few millimeters.
If the pull cord protrudes after the insertion of
the device, after which it becomes visible, it
can be easily custom-cut with a side cutter or a
pair of scissors. We recommend, however, that
you leave 2 ribs for easy removal from the ear.
Removing Qleaf Go from the ear
Hold the pull cord rmly and pull it – always
slowly - out of the ear.
7
Switching between programs
The Qleaf Go is set up with four programs. The
programs can be selected using the AirTAP™
function. To change between the programs,
the Qleaf Go wearer taps the ear gently with
the hand. The tap generates an air pressure
change that is detected by the Qleaf Go to
change the program. After the insertion of the
battery, the device is set by default to program
one. Gently tapping on the ear will produce
two beeps, indicating a switch from program
one to program two. After another gentle tap,
1
In the box
A Qleaf Go module
B Qleaf Go soft tip package
C Battery
D Battery ejection tool
E Carrying box
F Qleaf Go User manual
2
Placing the battery
While using a new battery: rst remove the
sticker from the + pole. Hold the module and
insert the battery as indicated.
3
Eject the battery
Hold the module and eject the battery with the
battery ejection tool.
If the module is placed in the soft tip, you can choose
to leave the soft tip partially on the device and only
‘peel o’ until you can easily access the battery
opening to eject the battery (see image 5, p. 5).
4
Inserting Qleaf Go in the
soft tip
I Insert the module into the soft tip with the
CE mark rst and visible.
II Next, simultaneously push the Qleaf Go
device with the thumb in the soft tip and
pull the pull cord.
III Please make sure that the module is
inserted all the way into the soft tip.
Make sure your hands are clean while inserting
the Qleaf Go. Make-up, cream, body oil, gel,
hairspray and likewise products can contaminate
the module and can, for example, contribute to
the clogging of the microphone opening.
5
Removing Qleaf Go from the
soft tip
I Pull the pull cord to the front of the
Qleaf Go and ‘peel’ the soft tip from the
module as far as possible.
II Place the Qleaf Go device (the part