User Manual
Table Of Contents
- 1. Introduction
- 1.1. Downloads & Updates
- 1.2. Installation
- 2. Touché
- 2.1. Overview
- 2.1.1. What is Touché ?
- 2.1.2. Slave and Standalone
- 2.1.3. Default Behaviour
- 2.2. Mechanism
- 2.2.1. Concept
- 2.2.2. Shiftings
- 2.2.3. Skin
- 2.2.4. Cylinders
- 2.2.5. Slider
- 2.3. Controls
- 2.3.1. Buttons
- 2.3.2. Encoder
- 2.3.3. LEDs
- 2.4. Connectivity
- 2.4.1. Ports
- 2.4.2. Data
- 3. Lié
- 3.1. Overview
- 3.1.1. What is Lié ?
- 3.1.2. System Requirements
- 3.1.3. Plug-in Formats
- 3.2. Interface
- 3.2.1. Menu
- 3.2.2. Settings
- 3.2.3. Browser
- 3.2.4. Slot Center
- 3.2.5. Plug-In Preset Specificities
- 3.2.6. Hardware Preset Specificities
- 3.2.7. Memory View
- 3.2.8. Scope
- 3.2.9. Sensitivity Curve Editor
- 4. Workflow
- 4.1. DAW Setup
- 4.1.1. Ableton Live
- 4.1.2. Logic Pro
- 4.1.3. Cubase
- 4.1.4. Presonus Studio One
- 4.1.5. GarageBand
- 4.2. Creating a new plug-in preset
- 4.3. Creating a new hardware preset
- 4.4. Loading a hardware preset in Touché’s internal memory
- 4.5. Adjusting your sensitivity
- 4.5.1. By Parameter
- 4.5.2. For the Top and Bottom Shiftings
- 4.5.3. For the Left and Right Shiftings
4.4. Loading a hardware preset in Touché’s internal memory
In addition to the generic, “Template” hardware presets, Lié comes with pre-mapped hardware presets. These are
based on the factory presets from a selection of modern synthesizers, and feature full parameter mapping instead
of just CC renaming, making the experience even more plug-and play.!
When loaded, each of those hardware preset sends a program change to the connected hardware synthesizer, so
that its preset matches the preset of Touché.
Those presets can also give you good example of parameters that could be interesting to use with your synth.!
!
To load and save a hardware preset inside Touché’s internal memory, connect Touché to your synthesizers with a
standard MIDI cable and our MIDI to Jack 3”5 break-out cable. Make sure that Touché is also connected to your
computer, and speaks to Lié.
Also make sure that your synth is on the same MIDI channel as Touché (by default Touché sends data to the MIDI
Channel 1). Receiving MIDI information can also be an option to choose on your synth that may not be activated by
default. Check its manufacturer’s manual and make sure this option is enabled.
To load a hardware preset temporarily, double click on its name in the browser. If Touché is connected to both Lié
and your hardware synth, it should now be controlling your synth.
Then, if you wish to save this hardware preset inside Touché’s internal memory, open the Menu, then click on
"MemoryView".
Expressive E
Touché User Manual v.1.2
Page of 35 37